Are you a member of the Splunk Community?
- Find Answers
- :
- Using Splunk
- :
- Splunk Search
- :
- Re: How do I match an IP address to a range that s...
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark Topic
- Subscribe to Topic
- Mute Topic
- Printer Friendly Page
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am trying to match IP addresses in the block of addresses - 10.120.1.0 through 10.120.13.255. This range spans several CIDR ranges
10.120.1.0/24 + 10.120.2.0/23 + 10.120.4.0/22 + 10.120.8.0/22 + 10.122.12.0/23. Is there a way to search not using eval cidrmatch?
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You could use a regex command to check if the ip matches the pattern and filter for these events
| regex ip="10.120.(?:[1-9]|1[0-3]).[0-255]"
Alternatively, you can just use cidrmatch with the case command.
| eval match=case(
cidrmatch("10.120.1.0/24" ,ip) ,"1",
cidrmatch("10.120.2.0/23" ,ip) ,"1",
cidrmatch("10.120.4.0/22" ,ip) ,"1",
cidrmatch("10.120.8.0/22" ,ip) ,"1",
cidrmatch("10.120.12.0/23",ip),"1",
1=1,"0")
HTH,
Raschko
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You could use a regex command to check if the ip matches the pattern and filter for these events
| regex ip="10.120.(?:[1-9]|1[0-3]).[0-255]"
Alternatively, you can just use cidrmatch with the case command.
| eval match=case(
cidrmatch("10.120.1.0/24" ,ip) ,"1",
cidrmatch("10.120.2.0/23" ,ip) ,"1",
cidrmatch("10.120.4.0/22" ,ip) ,"1",
cidrmatch("10.120.8.0/22" ,ip) ,"1",
cidrmatch("10.120.12.0/23",ip),"1",
1=1,"0")
HTH,
Raschko
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @Raschko wht this section of code 1=1,"0" on eval doing . Thanks
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The eval answer is just exactly what I needed. I need to have several other sub-nets defined and this lets me expand to cover all of them.
Thanks for the help!!
Scott
Splunk Enterprise Security(ES) 7.3 is approaching the end of support. Get ready for ...
Splunk Enterprise Security 8.x: The Essential Upgrade for Threat Detection, ...
Splunk Observability for AI
