Cisco Secure eStreamer Client (f.k.a Firepower eNcore) Add-On for Splunk 4.0.11 setup page missing

[rluhar_fs]

I just installed Cisco Secure eStreamer Client (f.k.a Firepower eNcore) Add-On for Splunk 4.0.11 from splunkbase but do not see setup link for initial interface.

After digging I found setup.xml is missing. 

Any fix for this? 

My splunk install is not in default location so during manual config it did throw lot of errors for openssl as well. I was finally able to configure it but wanted to see if setup page can be available in GUI.

[_joe · Accepted solution]

Version 4 did away with the interface.

The new steps for install are here:
https://www.cisco.com/c/en/us/td/docs/security/firepower/670/api/eStreamer_enCore/eStreamereNcoreSpl...