Splunk AppDynamics

Specific time based Health Rules

srimukundant
New Member

Hi, I also have the same issue 

I want to trigger the alert like below.

Once the alert starts, there should an alert.

After a certain amount of time, say 4 hours, I should get another alert. I should not get the alert in between.

Did anyone reply to this or is there any solution like setting up the throttle?

This post is related to this existing Community post: https://community.appdynamics.com/t5/Dashboards/Time-based-health-rules-not-possible/m-p/29930#M337

Labels (1)
Tags (2)
0 Karma

Hiroki_Ito
Contributor

Thank you for posting to the community.
As written in the last comment at the related post, you can use "Wait time after violation" to throttle the continuing health rule violations.

For example, if you set 240 minutes(4 hours) of "Wait time after violation" on a health rule and health rule violation continues for 4 hours, then you will get an alert at the beginning and after 4 hours.
* If the violation doesn't continue for 4 hours, you will get an alert after violation is triggered again even within 4 hours. By setting "Use data from last" with a large value, the violation may continue for a long time.

Best Regards,

Hiroki
Get Updates on the Splunk Community!

Splunk Observability Cloud's AI Assistant in Action Series: Auditing Compliance and ...

This is the third post in the Splunk Observability Cloud’s AI Assistant in Action series that digs into how to ...

Splunk Community Badges!

  Hey everyone! Ready to earn some serious bragging rights in the community? Along with our existing badges ...

What You Read The Most: Splunk Lantern’s Most Popular Articles!

Splunk Lantern is a Splunk customer success center that provides advice from Splunk experts on valuable data ...