- Splunk Answers
- :
- Splunk Administration
- :
- Installation
- :
- Getting error when trying to install Splunk.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark Topic
- Subscribe to Topic
- Mute Topic
- Printer Friendly Page
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Getting error when trying to install Splunk.
enter code hereHelp solve the problem. I can't install Splunk. During the installation, a message is displayed: Splunk Installer was unable to launch Splunk's Pre Flight Checks.
Error Code: 1
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
try this
Open the splunkd service and check the Log On tab. Is the service running as the local system or a user?
If your are running as a user, then review this from the Installation Manual:
Important: If you choose to run Splunk as another user, that user must:
•Be a member of an Active Directory domain (you cannot install Splunk as a local machine account other than the Local System account)
•Have local administrator privileges on the machine which you are performing the installation, and
•Have specific user rights, and other additional permissions, depending on the kinds of data you want to collect from remote machines.
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Open Cmd Prompt in Admin mode,go to dir where msi is kept, and run following cmd :
msiexec /a
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
for example msiexec /a splunk-6.1.1-207789-x64-release.msi
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I use a version of splunk-6.0-182037-x64-release.msi as administrator.
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I use a version of splunk-6.0-182037-x64-release.msi as administrator.
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I use a version of splunk-6.0-182037-x64-release.msi as administrator.
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Check that you have sufficient permissions to install to your location. Are you using the tgz or the rpm/deb?
Adoption of RUM and APM at Splunk
Routing logs with Splunk OTel Collector for Kubernetes
Welcome to the Splunk Community!
