Solved: UF using CLI - Splunk Community

Getting Data In

Greetings!

Just wanted to know the steps for adding an input to an UF using the CLI.

Thank you in advance.

1 Solution

Solution

It's in the docs at https://docs.splunk.com/Documentation/Splunk/8.0.5/Data/MonitorfilesanddirectoriesusingtheCLI

---
If this reply helps you, Karma would be appreciated.

View solution in original post

Solution

It's in the docs at https://docs.splunk.com/Documentation/Splunk/8.0.5/Data/MonitorfilesanddirectoriesusingtheCLI

---
If this reply helps you, Karma would be appreciated.

Get Updates on the Splunk Community!

Rounding off the Splunk Dashboard Contest

What does a contest-winning Splunk dashboard look like? In this case, it isn't in a browser tab at all. It ...

A Four Part Event Series: AI + Observability: AI Agents, LLMs, Apps, & Infrastructure

AI + Observability: AI Agents, LLMs, Apps, & Infrastructure The rapid evolution of artificial intelligence ...

Splunk Technical Support Is Moving to Cisco Support Tools

Introduction Splunk technical support is transitioning to Cisco’s support environment. This change brings ...