- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I was using a HF before and wanted to switch to a UF. I had a props.conf file in the etc/system/local with this:
[source::....(dat)]
sourcetype = mysourcetype
priority = 20
I am not not getting the newly installed UF to index the files. The reason to switch was we are not not doing anything else but read the file and forward on. Also was moving this to be managed by deployment server as well. Thanks.
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Actually this is working now. Looks like just some delay in getting the confs to come all in and data be read. Was just concerned when I was not seeing this that the props.conf file was being completely ignored due to being a UF.
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
look here:
http://wiki.splunk.com/Community:Troubleshooting_Monitor_Inputs
In Splunk 4.1 and later, you can access a debugging endpoint that shows status information about monitored files. https://your-splunk-server:8089/services/admin/inputstatus/TailingProcessor:FileStatus Note that this may change in the future, and is a somewhat rough prototype of the monitor behavior inspection.
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for the info, will help in the future. BTW - like the FileStatus. Looks like if UI is off (which it is on UF) then cannot use it.
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Actually this is working now. Looks like just some delay in getting the confs to come all in and data be read. Was just concerned when I was not seeing this that the props.conf file was being completely ignored due to being a UF.
- Mark as New
- Bookmark Message
- Subscribe to Message
- Mute Message
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Are you not seeing the files at all or is the sourcetype not assigned correctly? If the props stanza fails (I dont see why) then the inputs specified in inputs.conf should still be read and forwarded.