All Apps and Add-ons

Python for Scientific Computing Add-on Installation Error

AbdelrahmanAbde
Explorer

Hello Team ,

I'm using a single instance deployment for Splunk on windows Server 2012 R2
I wanted to install the MLTK so I followed the Installation Section in the documentation and tried to install Python for Scientific Computing Add-on first .
I'm using splunk web for the installation , tried to add .tgz file from the GUI to install the app but I always get the error of
Error connecting to /services/apps/local: ('The read operation timed out',)

What is the cause of that error and what should I correct to have it installed ??

0 Karma
1 Solution

grana_splunk
Splunk Employee
Splunk Employee

Uninstall previous version..install the latest one after restarting Splunk and if it still does not work..plz reboot your server.

I have seen same problem in past and sometimes windows registry does not clean up properly.Rebooting solves the problem

View solution in original post

grana_splunk
Splunk Employee
Splunk Employee

Uninstall previous version..install the latest one after restarting Splunk and if it still does not work..plz reboot your server.

I have seen same problem in past and sometimes windows registry does not clean up properly.Rebooting solves the problem

AbdelrahmanAbde
Explorer

Thanks Grana

I uninstalled the App , restarted Splunk and rebooted the server then I installed the Add-On again and it worked fine this time .

0 Karma

Sukisen1981
Champion

can you try a direct install from the web?
click on apps settings gear button > browse more apps > search for Python for Scientific Computing
and choose the relevant one for which the isntall button in green background will be enabled?

0 Karma

AbdelrahmanAbde
Explorer

Hi Sukisen ,

Thanks for your reply
I followed the steps you mentioned but I can't find the green install button instead I found a *Already installed button * and it is dimmed

0 Karma

Sukisen1981
Champion

uhhh i was doubting it maybe from some previous installation that you were trying
can you go to etc/apps and delete the installed folder for python for scientific app
and then try re-install through the web?

AbdelrahmanAbde
Explorer

I did so and it worked
Thanks Susiken

0 Karma
Get Updates on the Splunk Community!

A Prelude to .conf25: Your Guide to Splunk University

Heading to Boston this September for .conf25? Get a jumpstart by arriving a few days early for Splunk ...

4 Ways the Splunk Community Helps You Prepare for .conf25

.conf25 is right around the corner, and whether you’re a first-time attendee or a seasoned Splunker, the ...

Enhance Your Splunk App Development: New Tools & Support

UCC FrameworkAdd-on Builder has been around for quite some time. It helps build Splunk apps faster, but it ...