Increasing UI timeout in LDAP Group configuration

Splunk Search

I am trying to increase the "Network Socket timeout" in the LDAP group configuration.

I tried modifying parameters as mentioned in this vlog: https://community.splunk.com/t5/Splunk-Search/LDAP-Group-Configuration-Can-I-increase-the-search-req...

Though the value reflects fine on UI, when I edit anything on UI for LDAP settings it errors out with the message - "Invalid network timeout". Am unable to figure out which is the param against which the set value is verified. Any help would be appreciated. TIA

Get Updates on the Splunk Community!

Rounding off the Splunk Dashboard Contest

What does a contest-winning Splunk dashboard look like? In this case, it isn't in a browser tab at all. It ...

A Four Part Event Series: AI + Observability: AI Agents, LLMs, Apps, & Infrastructure

AI + Observability: AI Agents, LLMs, Apps, & Infrastructure The rapid evolution of artificial intelligence ...

Splunk Technical Support Is Moving to Cisco Support Tools

Introduction Splunk technical support is transitioning to Cisco’s support environment. This change brings ...