How to add new member to SHC?

[vinothkumark]

Hi All, 

I have a requirement to add new members to the existing SH Cluster.

I have gone through the below link where it explains about adding member to the SHC. 

Add a cluster member - Splunk Documentation

How do I Integrate it with the CM/Indexers? Do I need to do it after the above one? Is there any link?

[richgalloway]

Once the new member is added to the cluster it will get its configs from the SHC Deployer and get updates from the Captain.  Those configs should include CM/peer info so no additional steps are needed.

[isoutamo]

Hi

I'm not sure what is current situation, but if @richgalloway 's instructions is not enough. Then you must add manager node to this member directly. I recall that at least earlier (7.x) there was some server.conf (?) parameter which need to enabled for replicating CM information over all SHC members, but I could remember wrongly and couldn't find that information from docs now. 

Here is link for what is needed on SHC member to add CM to it Integrate with a single-site indexer cluster with multisite you found later inside that doc.

r. Ismo