Splunk Dev

Unable to access/comprehend manifest file in SPLUNK_HOME directory.

blazingwebs
New Member

New install, I must have accidentally deleted the manifest file thinking it was the original installer - how can I take care of the error? (it doesn't impact performance just shows in Messages)

0 Karma
1 Solution

BlueSocket
Communicator

I suggest that you tar the splunk folder into a file (to backup) and then re-run the installer. If the installation is REALLY new, then why not just delete the SPLUNK_HOME and then re-run the installer (yum install splunk*.rpm) or tar xvf splunk*.gzip?

View solution in original post

0 Karma

BlueSocket
Communicator

I suggest that you tar the splunk folder into a file (to backup) and then re-run the installer. If the installation is REALLY new, then why not just delete the SPLUNK_HOME and then re-run the installer (yum install splunk*.rpm) or tar xvf splunk*.gzip?

0 Karma
Get Updates on the Splunk Community!

Your Guide to SPL2 at .conf24!

So, you’re headed to .conf24? You’re in for a good time. Las Vegas weather is just *chef’s kiss* beautiful in ...

Get ready to show some Splunk Certification swagger at .conf24!

Dive into the deep end of data by earning a Splunk Certification at .conf24. We're enticing you again this ...

Built-in Service Level Objectives Management to Bridge the Gap Between Service & ...

Now On-Demand Join us to learn more about how you can leverage Service Level Objectives (SLOs) and the new ...