After installing a universal forwarder on on Active Directory, how do I configure the account, logs to be collected, and the target indexer?

[samehatef]

Hi,

I tried to install the Universal Forwarder on Active Directory, but I did not get a window during installation phase to enter the username and password of the account to install with and which logs should be collected and what is the indexer to send these logs to.

How can I configure that after installation is done and I was not able to make these conf. during installation ?!

[renjith_nair]

You can either do it from the web or editing the files
Refer to

http://docs.splunk.com/Documentation/Splunk/6.2.0/installation/installonWindows

and

http://docs.splunk.com/Documentation/Splunk/6.2.0/Data/MonitorWindowsdata

[samehatef]

I am asking about Universal Forwarder not Splunk itself ?!

[renjith_nair]

Did you get a chance to look at the documentation mentioned above ?: http://docs.splunk.com/Documentation/Splunk/6.2.0/Data/MonitorWindowsdata

also

http://docs.splunk.com/Documentation/Splunk/6.2.0/Forwarding/Setupforwardingandreceiving

and

http://docs.splunk.com/Documentation/Splunk/6.2.0/Data/Configureyourinputs

Go thru these docs and refer to the sub links if necessary. It has all details about configuring your UF