Splunk Enterprise

cluster manager redundancy setup issue

ltang78
Engager

We setup two cluster managers with load balancer, according to this document. 

According to the document, The active manager should respond with 200 for health check probe while the standby managers respond with 503. However, in our case, both responds with 200. In addition, when running the following command on each cluster manager, instead of listing all cluster managers, only the current node is output. What could be the problem in the setup?

 

splunk cluster-manager-redundancy -show-status

 

Labels (2)
0 Karma

meetmshah
Builder

Better to raise Splunk Support case for better troubleshooting 🙂

0 Karma
Get Updates on the Splunk Community!

Message Parsing in SOCK

Introduction This blog post is part of an ongoing series on SOCK enablement. In this blog post, I will write ...

Exploring the OpenTelemetry Collector’s Kubernetes annotation-based discovery

We’ve already explored a few topics around observability in a Kubernetes environment -- Common Failures in a ...

Use ‘em or lose ‘em | Splunk training units do expire

Whether it’s hummus, a ham sandwich, or a human, almost everything in this world has an expiration date. And, ...