All Apps and Add-ons

Issue with Pantag in Palo Alto Networks app

jb1982
Path Finder

Good afternoon, and thanks in advance for any suggestions

We are trying to pantag search results in an alert to a dynamic address group. The addresses are not showing up into the dynamic group until someone runs a commit. The same holds true when we pantag to remove tags. I'm beating my head against the wall here, any suggestions are welcome!

Thank you!

0 Karma
1 Solution

jb1982
Path Finder

So, i think i figured this out. I was trying to test this without the dynamic group being in a committed policy, because i didn't want to break anything. Doesn't work that way. The tags will only apply without a commit if the dynamic group is referenced in a policy that is committed to the running config. I hope this helps anyone who is having the same issue!

View solution in original post

0 Karma

jb1982
Path Finder

So, i think i figured this out. I was trying to test this without the dynamic group being in a committed policy, because i didn't want to break anything. Doesn't work that way. The tags will only apply without a commit if the dynamic group is referenced in a policy that is committed to the running config. I hope this helps anyone who is having the same issue!

View solution in original post

0 Karma
.conf21 Now Fully Virtual!
Register for FREE Today!

We've made .conf21 totally virtual and totally FREE! Our completely online experience will run from 10/19 through 10/20 with some additional events, too!