...an't seem to find a way to put a drilldown with it. I am using a inpage drilldown with a single value which just works fine but unable to find any drilldown setting with the water gauge.
Can someone h...
...ould make a filler gauge only use the value of one field.
Is there any possibility on how to do this? I could run the same search four times and just adapt the "table" command, but in this case, I c...
...ndexname/sourcetypename you specify. What I want is a gauge that will find the license pool size to set it's limits. Using the below search on its own I am able to return the desired ranges:
| rest s...
Our gauge needs to display from 0 to 1, but after installing 4.3, the scale only shows 0 - 100.
Below is the xml I am using. What am I doing wrong?
<chart>
<searchName>A...
Hey everyone. I have a data source which contains license usage information.
Each source contains a line like this:
Group License: 10 of 123453 used.
I am capturing these using a regex, a...
Hello, I am using a Filler Gauge in one of my dashboards and I would like to use values with 2 decimal values, but I do not see any precision option for Gauge Viz. for example, I would l...
I am trying to create a gauge where the green, yellow, red are dynamically adjusted using average and percentages for similar traffic over the past 30 days. The 30 day search takes a while so what I...
I am trying to create a radial gauge chart to display a particular event rate. Without aggregation the chart shows up but once i add avg by a timespan the chart becomes blank.
index="my_index"
"M...
I am using a rangemap function for iis data. I am counting the amount of succesful 'hits' in a log (status=2*) and I'm attempting to map the results to a radial gauge however splunk is truncating t...