Here is what I found in case you were wondering what I am asking for. Point 2# looks like ITSI doesn’t understand 0 as its lower value?) 1. If we are defining threshold values in Ascending order- We are good as ( example Error Rate Threshold, where anything above 60% is Critical, while we start from 0- Normal, 10-Low,20-Medium, 40- High, So ITSI know that any number above 60 will be marked as Critical. 2. If we are defining threshold values in Descending order – We need to make sure we end up with 0. As its lowest value . Normal -6 , Low-5,Medium-4,High-3,Critical-2 ( I can’t do this , as If I have value as 1 it will saydefault Severity Not Critical), While I m anticipating it to know that anything below 2 until 0 should be critical .
Fix - I have to say Critical-0. Then model is reflecting/report correctly as Critical failure.
So, Can the model just like in Ascending case where it know its 100% max.Can it have a boundary defination for 0 is Minimum for Descending Values?