Deployment Architecture

multisite RF & SF are not correctly representing in master UI

mchang_splunk
Splunk Employee
Splunk Employee

I setup one multisite with the following server.conf

[clustering]
available_sites = site1,site2,site3
mode = master
multisite = true
site_replication_factor = origin:2,site1:2,site2:2,site3:2,total:6
site_search_factor = origin:2,site1:2,site2:2,site3:2,total:6

However, in master UI, I still see RF=3, and SF=2, which is the default value of singlesite.
alt text

Is this a bug?

0 Karma
1 Solution

mchang_splunk
Splunk Employee
Splunk Employee

This is a known issue SPL-87142 which is only on multisite clustering.
If you're on single site, it's working well.

View solution in original post

0 Karma

mchang_splunk
Splunk Employee
Splunk Employee

This is a known issue SPL-87142 which is only on multisite clustering.
If you're on single site, it's working well.

0 Karma
Get Updates on the Splunk Community!

Your Guide to SPL2 at .conf24!

So, you’re headed to .conf24? You’re in for a good time. Las Vegas weather is just *chef’s kiss* beautiful in ...

Get ready to show some Splunk Certification swagger at .conf24!

Dive into the deep end of data by earning a Splunk Certification at .conf24. We're enticing you again this ...

Built-in Service Level Objectives Management to Bridge the Gap Between Service & ...

Now On-Demand Join us to learn more about how you can leverage Service Level Objectives (SLOs) and the new ...