Deployment Architecture

Estimating index storage requirements?

rturk
Builder

Hi Splunkers,

I've been doing some design documents for a fairly large distributed deployment of Splunk:
- 100GB/license
- 2 geographically separated sets of 2 VM indexers (w/ direct attached storage)
- 90 days retention required

I'm now up to the point of estimating the amount of storage I need to give to each of the Indexers (assuming the load is shared evenly among them), however I've come upon a bit of a contradiction in the doco:

From Hardware Capacity Planning for your Splunk Deployment:

At a high level, total storage is
calculated as follows:
daily average rate x retention policy x 1/2

So, given my specs above:

100GB x 90 days X 1/2 = 4.5TB total storage required between 4 indexers = 1.125TB/Indexer

BUT, from Estimate your storage requirements:

Typically, the compressed rawdata file
is approximately 10% the size of the
incoming, pre-indexed raw data. The
associated index files range in size
from approximately 10% to 110% of the
rawdata file.

So, given my same specs:

100GB/day x 90 days = 9TB total raw data to be indexed
(9TB x 10%) + ((9TB x 10%) x 110%) = 1,890GB total storage between 4 indexers = 472.5GB/Indexer

Have I missed something here? Which recommendation am I meant to run with?

Tags (3)
1 Solution

_d_
Splunk Employee
Splunk Employee

Yes, you have 🙂 and the usage of the word "index" is the reason you're being mislead in this case.

When raw data is indexed, for each bucket, at a minimum, we store:

  • an index structure that is associated with it (think of the index at the end of each book)
  • a compressed file which contains the actual raw data (this is where your events are stored).

So the math goes like this:

index size = (index structure) + (compressed raw data) = 1/2 (size of uncompressed raw data)

Given your specs, this is what you should use to calculate:

100GB x 90 days X 1/2 = 4.5TB total storage required between 4 indexers = 1.125TB/Indexer

Hope this helps,

d.

View solution in original post

theunf
Communicator

I think you all missed the point of what replication_factor was used here and, maybe, if multisite cluster replication were used.

If the second option where not used and replication factor was 4, each log will reside on each node, so each node will need 4.5Tb of disk.

Same scenario with a replication factor of 2: If only 1 onde recieve logs, 2 nodes will use 4.5Tb and the other 2 nodes will recieve nothing. The replication pair selection is automatic and you may see it by searching on _audit or at settings->indexes at each node.

_d_
Splunk Employee
Splunk Employee

Yes, you have 🙂 and the usage of the word "index" is the reason you're being mislead in this case.

When raw data is indexed, for each bucket, at a minimum, we store:

  • an index structure that is associated with it (think of the index at the end of each book)
  • a compressed file which contains the actual raw data (this is where your events are stored).

So the math goes like this:

index size = (index structure) + (compressed raw data) = 1/2 (size of uncompressed raw data)

Given your specs, this is what you should use to calculate:

100GB x 90 days X 1/2 = 4.5TB total storage required between 4 indexers = 1.125TB/Indexer

Hope this helps,

d.

lzhang_soliton
Path Finder

d,
I am looking for the math to know the change of the size between before and after indexing. Could you point me how you get the math?
I calculate the size according to the document as R.Turk wrote.
raw data size: 9TB
"rawdata file size": 9TB x 10%
Minimum index size: (9TB x 10%) + ((9TB x 10%) x 10%)
Maximum index size: (9TB x 10%) + ((9TB x 10%) x 110%)
Thank you in advance.

0 Karma

rturk
Builder

Thanks d, I was probably going to err on the side of caution anyway, but this is the answer I was looking for cheers 🙂

0 Karma
Get Updates on the Splunk Community!

Take Your Breath Away with Splunk Risk-Based Alerting (RBA)

WATCH NOW!The Splunk Guide to Risk-Based Alerting is here to empower your SOC like never before. Join Haylee ...

Industry Solutions for Supply Chain and OT, Amazon Use Cases, Plus More New Articles ...

Splunk Lantern is a Splunk customer success center that provides advice from Splunk experts on valuable data ...

Enterprise Security Content Update (ESCU) | New Releases

In November, the Splunk Threat Research Team had one release of new security content via the Enterprise ...