I just installed Cisco Secure eStreamer Client (f.k.a Firepower eNcore) Add-On for Splunk 4.0.11 from splunkbase but do not see setup link for initial interface.
After digging I found setup.xml is missing.
Any fix for this?
My splunk install is not in default location so during manual config it did throw lot of errors for openssl as well. I was finally able to configure it but wanted to see if setup page can be available in GUI.
Version 4 did away with the interface.
The new steps for install are here:
https://www.cisco.com/c/en/us/td/docs/security/firepower/670/api/eStreamer_enCore/eStreamereNcoreSpl...
Version 4 did away with the interface.
The new steps for install are here:
https://www.cisco.com/c/en/us/td/docs/security/firepower/670/api/eStreamer_enCore/eStreamereNcoreSpl...