topic Re: How do I exclude errors and exceptions from detection? in Splunk AppDynamics

How do I exclude errors and exceptions from detection?

Gopi_Krishnan — Wed, 25 Nov 2020 12:39:11 GMT

Is there a way to capture some part of the logged messages and ignore the rest? I have Errors which are logged via logger and appdynamics is capturing that but including some other information which is not required.

Regards,

Gopikrishnan

Re: How do I exclude errors and exceptions from detection?

iamryan — Wed, 09 Dec 2020 23:49:05 GMT

Hi @Gopi.Krishnan,

Sorry for the late reply. After speaking with a few people, for this issue, it's best if you contact support.

www.appdynamics.com/support

If you could share the end results of the conversation as a reply to this post that would be very helpful. Knowledge sharing is what drives this community forward.

Re: How do I exclude errors and exceptions from detection?

Nawaz_Ali_Moha1 — Wed, 06 Jan 2021 07:52:27 GMT

Hello Gopi,

I might not have understood your question completely by there is one KB article which talks about how to suppress errors and exceptions.
https://community.appdynamics.com/t5/Knowledge-Base/How-do-I-exclude-errors-and-exceptions-from-detection/ta-p/13968

Re: How do I exclude errors and exceptions from detection?

Gopi_Krishnan — Wed, 06 Jan 2021 08:10:21 GMT

Hi Nawaz,

I had checked the link shared by you and it mentions how to ignore a whole message from being detected. But my case is somewhat like below :

Error response received : [{"metadata":{"Code":["ERROR_50404"],"Message":["HOLDN ERRORS ERROR INSUFFICIENT FUNDS FOR THIS TRANSACTION"],"StackStrace":" at HoldNAPI.Controllers.v1.HoldFundController.d__2.MoveNext()"},"data":{"mob":"XXXXXXX"}}]

I want to just captured the Code highlighted in Red and ignore the remaining. Is this case possible at all?

Regards,

Gopikrishnan