topic Re: Help for configuring Health Rule schedule in Splunk AppDynamics

Help for configuring Health Rule schedule

Rakshit_Patki — Thu, 06 Feb 2025 02:46:46 GMT

I have created a custom extension that captures the status of the Scheduled Job (e.g., Ready, Running, Others) and sends the data to AppDynamics as 1, 2, etc. respectively.

Do we have any feasibility of configuring Health Rules to accommodate the following conditions:

TaskName	Triggers
Failure_PushData_ToWellnessCore_CRON	Start at 12 AM and execute every 3 Hrs
PushToWellness fromDbtoConsoleApp	Start at 5 PM and execute every 3 Hrs
Wellnessdatacron	starts at 12.01Pm and execute every 1 hr
WellnessFailureCRON	9am, 12am, 3pm, 6pm, 10pm, 1am, 5 am
NoiseDataSyncCron	Start at 11Am and execute every 1hr
NoiseWebhookProcessor	Start at 11Am and execute every 2hrs

I tried configuring Cron with Start time as 0 17/3 * * * and End time 59 23 30 4 * as to accommodate "Start at 5 PM and execute every 3 Hrs " condition as a Health rule schedule but I am getting error as Error creating schedule: Test. Cause: Unexpected end of expression.

Can anyone help me with this?

Re: Help for configuring Health Rule schedule

iamryan — Wed, 12 Feb 2025 17:33:15 GMT

Hi @Rakshit.Patki,

Thanks for asking your question on the community. It's been a few days with no reply from the Community. Did you happen to find any additional information or a solution you can share?

If you still need help, you can contact AppDynamics Support: How do I open a case with AppDynamics Support?

Re: Help for configuring Health Rule schedule

Rakshit_Patki — Sat, 08 Mar 2025 10:36:53 GMT

Thanks, @iamryan for following up!

I have found the solution to my problem. I just need to configure the Health-rule so that an alert is triggered if the metric value is less than 1 at any given time.

Since even if the task is not running, it will remain in the READY state in the Task Scheduler, with a value of 2, and for any other state, the value will be 0.